How To Paint Metal Patio Chairs

The decor and furnishing in your house means a lot to the overall feel of it and being able to paint metal permits you to increase the lifespan of certain furniture. Metal chairs tend to be luxurious and are regularly found as dining room furniture. Metal paint can be used to paint metal chairs in order to go with any paint job that you can have in store with the rest of the home. This blog consists information on how you can paint metal chairs.

 
Step-1 Prepare Chairs

Place on drop cloth and check out for any harm. You will only need to re-use chairs that have not any damaged pieces or at risk for breaking.

Step-2 Sand Off The Rust

Utilize your stiff wire brush to acquire through thick rust. Utilize some muscle to get rid of rust as some chairs have wear and tear from many years. Wear a mask and safety glasses while sanding to secure skin eyes and lungs. Sand the rest of the chair together with your sanding block or fine grit sandpaper. Smooth over any rough patches without scratching metal.

Step-3 Clean With Solvent

Once the surface is clean and even, wipe it down with a solvent like acetone to make sure the chair is clean and prepared for painting and clear coating.

 
Step-4 Spray on Paint

Utilize Rust-Oleum Specialty Fluorescent Spray Paint which are available in green, orange, yellow, pink and red-orange colors. It is specially designed for outdoor utilisation to avoid rust. Spray using a backward and forward motion, holding the can far enough away for a constant spray pattern to avoid drips and over spray. Follow the natural lines of the chair to coat it equally. Utilize a sweeping, continuous motion when spraying on the paint. Apply several very light coats to make sure a professional level of coverage.  Remember to get the back and underside.

Step-5 Protect With Clear Coat

Spray the chairs with a final protective coat of spray lacquer for a glossy finish. Even with rust preventing spray paint, a clear coat is a clever idea. Use Rust-Oleum Specialty Lacquer Spray Paint that’s for outside use, preferably with UV protection to help avoid fading. Hold the can 10” to 12” away and spray utilizing a backward and forward motion. Follow the natural lines of the chair to coat it equally.

 
Step-6 Let it Dry

Be sure to permit the chair cure for 24 hours in a warm, dry, well-ventilated area prior using. This chair is now rust-free, repainted and ready for some more years of outdoor use.

Tips

• Shake the Rust-Oleum can for approximately 30 seconds.
• You need to hold the can 6-10 inches from the chair.
• Move it well from left to right for horizontal sections and from top to bottom for vertical areas.
• Let paint dry for 30 to 45 minutes earlier than applying a subsequent coat.
• Place the legs of the chairs on top of old pieces of metal.
• That last tip, using old pieces of metal, will assist you get an even paint job on the bottom part of the chair’s legs. This is even more significant if you have a drop cloth on top of concrete that you don’t want to ruin.