How to Paint Brick, MDF, Metal, and Plastic

How to Paint Brick, MDF, Metal, and Plastic

Paint has a grace all its own and can be perceived more and more as decorating traits shift. Spray paint onto wood and drywall is a snap. It's a number of the other materials found around the home that can be complex. Here, instructions on getting the color coating proper the first time.

How to Paint Brick MDF Metal and Plastic

Brick

Preparation: The main point of the preparation is to clean any dust, dirt, and loose paint. Once the washing is completed, let the brick plenty of time to fully dry. Remove all loose paint that is left behind on the brick face or else it’ll cause early chipping when you ultimately apply your coat. Sand the brick smooth utilizing either a palm or circular sander with a minimum 80 grit paper.

Paint: You need to seal pores with a water-based primer designed for masonry, and coat with spray paint. Paint the space utilizing smooth up and down spray strokes. Apply a thin coat so that it doesn’t get bubble. Begin by masking the top strip of the area with spray paint and work your way down until the whole area has a thin cover of paint. Once the first coat is absolutely dry, apply a second coat following the same process.

MDF

Preparation: Medium Density Fiberboard (MDF) is a perfect wood to utilize for many interior home furnishings for example cabinetry because it is more constant and cheaper than hardwood. MDF sometimes comes pre-primed, however if yours isn't, then you need to prime the surface earlier than painting. You can utilize any sort of water-based primer, consisting of an emulsion paint or an acrylic primer. It will save it from being affected by the color of the board. 

Paint: When you are painting hard areas, paint brushes and paint rollers work well. For extra intricate pieces, it's great to utilize spray paint instead of a brush or roller. Spray painting the MDF can cover the surfaces more consistently without resulting in an extreme buildup of paint. Also have in mind that painting both sides of the board will help to save it from bowing after the paint dries.

Metal

Preparation: Remove dirt or different particles with a wet rag. Clean the surface with mineral spirits and a rag to get rid of dirt and other grime. Make sure to go over the whole surface of the metal. Then, you may let the metal to air dry or swiftly go over it with a cloth. Then, start sanding the surface with 120-grit sandpaper

Paint: Work from side to side to cover the metal with equal strokes with a can of spray paint or paint applied from a sprayer or airbrush. For spray paints, you need to hold the can 10 to 12 inches from the floor, moving parallel to the floor at a constant speed as you paint. Pick the suitable tips as advised by the manufacturer for the specific paints used.

Plastic

Preparation: For this, wipe down the surface down with rubbing alcohol. This will evacuate any surface dirt and decrease the amount of work you have to do in later steps. Utilize a soft cloth or sponge for smooth surfaces, and a scrubbing brush for textured surfaces (for example patio furniture). Rinse the item with clean water afterwards, then dry it off. You’ll need to apply a coat of primer, ideally one that bonds nicely. 

Paint: Spray paint works specifically fine for plastic, but you can utilize acrylic or enamel/model paint as well. Before you start painting, check the label on your cane or bottle of paint for any detailed instructions. Let the each coat of paint to dry before applying the next one. How many layers you apply depends on the coverage you want.

Back to blog